32 | ni.com | NI myDAQ User Guide
15. On the Configuration tab of the DAQ Assistant front panel window, configure voltage
channel 0 by selecting VoltageOut_0 in the Channel Settings pane, and setting Max to
2
and Min to
-2 in the Signal Output Range pane. Repeat this step for voltage channel 1 if
you configured the task for two channels.
16. Under Timing Settings, set Generation Mode to Continuous Samples.
17. Click OK to exit the DAQ Assistant configuration front panel. The VI builds. Click No on
the Confirm Auto Loop Creation dialog box that displays.
18. Wire the data output terminal of the first DAQ Assistant Express VI to the data input
terminal of the second DAQ Assistant Express VI.
19. Add a While Loop to the block diagram by right-clicking the block diagram window and
selecting Programming»Structures»While Loop from the Functions palette, and drag
out a rectangular region to enclose both DAQ Assistant Express VIs.
To Next Page
Loading...