NI myDAQ User Guide | © National Instruments | 33
20. Add a STOP control to your front panel by right-clicking the STOP button and selecting
Create Control.
21. Click the Run button to test your LabVIEW application.
22. Attach a music player to the AUDIO IN 3.5 mm jack, and connect speakers to the AUDIO
OUT jack. You should hear the music on the speakers. If you do not hear sound, test the
speakers on the music player to make sure there is sound playing and that the speakers are
functioning properly.
This example provides the basis for audio measurement. Experiment further by placing digital
signal processing steps such as filters between the input and output.
To Next Page
Loading...