National Instruments SCXI Series - Page 153

Index
Getting Started with SCXI I-4 www.ni.com
See specific modules
jumpers
accessing, 3-2
L
LabVIEW software
addressing SCXI-1200 analog input
channels, A-2
overview, 1-15
problems with SCXI-1100 module, A-2
LabWindows/CVI software, 1-15
LVDTs
connecting to, 4-32
M
manual. See documentation.
MISO signal
connectingtoSERDATOUTpin
SCXI-1120/D module, 3-14
SCXI-1121 module, 3-23
SCXI-1140 module, 3-32
multichannel scanning, 1-18
multichassis system with plug-in DAQdevice,
1-14
multiplexed mode of operation, 1-17
N
National Instruments Web support, B-1
NI Developer Zone, B-1
NI-DAQ driver software, 1-15
noise reduction for thermocouples, 4-9
nonreferenced single-ended (NRSE) mode
description, 3-53
Lab devices, 3-3
SCXI-1200 configuration (table), 3-52
NRSE. See nonreferenced single-ended
(NRSE) mode.
O
output signal referencing
SCXI-1120/D module, 3-13
SCXI-1121 module, 3-23
SCXI-1140 module, 3-30
P
parallel communication modes
configuration and jumper settings
SCXI-1162 module, 3-40
SCXI-1163 module, 3-45
description, 3-37
parallel mode of operation, 1-17
parallel port connections
SCXI systems, 2-2
SCXI-1200 module, 3-50
PGIA output referencing modes
SCXI-1100 module, 3-6
polarity settings for SCXI-1200 module
analog I/O settings (table), 3-51
configuration, 3-54
factory settings, 3-51
jumper settings (table), 3-54
problems and solutions, A-1
R
referenced single-ended (RSE) mode
description, 3-53
Lab devices, 3-3
SCXI-1200 configuration (table), 3-52
relay multiplexer for RTDs, 4-24
relays for SCXI-1122
avoiding mechanical wear on (note), 3-25
requirements for getting started, 1-3
Resistance-Termperature Detectors (RTDs).
See RTDs.
resolvers
connecting to, 4-35