¼ Note: Also used for menu scrolling, editing, and backlight level adjustment.
F Channel DOWN
Short press
decreases one channel.
¼ Note: You can also directly select a channel by typing the channel number on the keypad.
Long pressing the key will, after a short delay, step rapidly through the channels.
¼ Note: Also used for menu scrolling, editing, and backlight level adjustment.
G OK / HL
Short press to make selections in menus.
Long press to toggle transmission power between HIGH (25 W) or LOW (1 W) for the entire channel
bank. The HI or LO selection is displayed on the LCD.
¼ Note: Some channels allow only low power transmissions. Error beeps will sound if attempting to
change the transmission power while on one of these channels.
¼ Note: Some channels allow only low power transmissions initially, but can be overridden to high
power by pressing (and holding) H/L after depressing PTT. Keep the H/L key pressed down after
releasing the PTT key, if wanting to transmit again on high power.
H VOL / SQL selector
Short press to toggle between Volume or Squelch control. The selected control is indicated by a small
triangular arrow above the level bar for each option on the display. Use the + and - keys to adjust.
¼ Note: Volume control is common to internal and external speaker.
Long press to open SHORTCUTS menu.
I +
Short press to increase the selected control (Volume and Squelch).
J -
Short press to decrease the selected control (Volume and Squelch).
K DSC / MENU
Short press to enter the DSC Call Menu and make DSC calls.
Long press to open the MENU SELECT page.
L AIS / IC
Short press to enter the AIS (Automatic Identification System) mode (NRS-2 only; no function on
NRS-1). Refer to “AIS setup” on page 28 for AIS setup and functionality.
Long press to enter Intercom / Hailer / Fog Horn / Announce mode.
M Weather
Short press (US/CAN country mode): press to hear the most recently selected NOAA/Canadian
weather station. For non US/CAN country modes, changes channel to user programmed choice.
When in ATIS mode, will select CH10.
Long press (non US/CAN country mode): to store current channel as the weather, local harbor or
preferred channel.
N / SCAN / -
• Menu mode:
Short press to move the cursor one character to the left
• Normal radio mode:
Short press to enter ALL SCAN mode.
Long press to enter the SCAN menu.
• AIS mode (NRS-2 only):
Short press to decrease (zoom in) the scale of the AIS plotter out one range at a time. The scales
available are: 1, 2, 4, 8, 16, 32 nm.
O / TRI / +
• Menu mode:
Short press to move the cursor one character to the right
16 |
General information | RS100 / RS100-B / V100 / V100-B User Manual
To Next Page
Loading...
Need help?
General
