EU RF exposure compliance notice for xed mount VHF
To be protected against all verified adverse effects, the separation distance of at least 2.1 m must be
maintained between the antenna of the radio having max. 6 dBi antenna and all persons.
Countries of intended use in the EU
AUT - Austria BEL - Belgium BGR - Bulgaria CHE - Switzerland
CYP - Cyprus CZE - Czech Republic DEU - Germany DNK - Denmark
EST - Estonia ESP - Spain FIN - Finland FRA - France
GRC - Greece HRV - Croatia HUN - Hungary IRL - Ireland
ISL - Iceland ITA - Italy LIE - Liechtenstein LTU - Lithuania
LUX - Luxembourg LVA - Latvia MDA - Moldovia MLT - Malta
NLD - Netherlands NOR - Norway POL - Poland PRT - Portugal
ROU - Romania SKK - Slovak Republic SRB - Serbia SWE - Sweden
SVN - Slovenia TUR - Turkey GBR - United Kingdom
United States
Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
⚠Warning: The user is cautioned that any changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
RF emissions notice
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device’s antenna must be installed in accordance with provided instructions; and it must be operated
with minimum 2.1 m spacing between the antennas and all person’s body (excluding extremities of
hands, wrist and feet) during operation. Further, this transmitter must not be co-located or operated in
conjunction with any other antenna or transmitter.
¼ Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that the interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that of the receiver is connected.
• Consult the dealer or an experienced technician for help.
RF exposure compliance statement for wireless handset (HS40, H60)
This device was tested for typical body-worn operations. To comply with RF exposure requirements, a
minimum separation distance of 0 mm must be maintained between the user’s body and the handset,
including the antenna.
FCC Part 18 compliance statement for cradle charger (BC-12)
This device complies with Part 18 of the FCC Rules.
⚠Warning: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the product.
¼ Note: This equipment has been tested and found to comply with the limits for a wireless power
transfer, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable
| 5
Preface | RS100 / RS100-B / V100 / V100-B User Manual
To Next Page
Loading...
Need help?
General
