MOB and NAV functions
Man Over Board (MOB)
An MOB is generated by press and hold SCAN and TRI keys together.
The screen will change to MOB navigation mode to help navigate back to the MOB location:
• DST shows the current distance to MOB waypoint.
• STEER shows the current bearing to MOB waypoint direction indicators showing:
• for turn to port,
• for straight ahead, and
• for turn to starboard.
¼ Note: An MOB waypoint is sent to a connected MFD via NMEA 2000.
¼ Note: You can also manually send a MAN OVERBOARD DISTRESS message via DSC. When in DISTRESS,
select the MAN OVERBOARD category.
Long press the
SCAN and TRI keys at the same time to set a new MOB waypoint at the current
location. A pop up screen will appear with 2 choices:
• RESUME CURRENT MOB: to close pop up and resume current MOB navigation.
• CREATE NEW MOB: to cancel current MOB navigation and create a new Man-Over-Board (MOB)
waypoint at the current location.
Short press X/POWER to close the pop up and resume current MOB navigation.
Long press X/POWER to exit MOB navigation. A pop up screen will appear with 2 choices:
• KEEP CURRENT MOB: to return to normal operation mode without cancelling MOB navigation.
• CANCEL CURRENT MOB: to cancel current MOB navigation and return to normal radio operation mode.
8
46 |
MOB and NAV functions | RS100 / RS100-B / V100 / V100-B User Manual
To Next Page
Loading...