Navico Simrad RS100 User Manual

Wireless handset (WHS)
Pair a wireless handset
The pairing process only needs to be performed once per WHS:
1 Ensure the WHS that you want to pair to the radio is charged and turned OFF.
¼ Note: Ensure all other WHS’s remains OFF during this procedure.
2 Access the radio’s Main menu from a fixed handset, and select HANDSETS > WIRELESS HANDSET.
3 Select PAIR A HANDSET. Select YES.
4 Turn ON the wireless handset that you want to pair to the radio. The WHS display will show
SEARCHING...
5 Press and hold the SCAN key on the WHS until HANDSET IS PAIRING appears.
¼ Note: The wireless handset will search for the host radio, if it locates the radio it will complete the
pairing process within few minutes.
6 Repeat steps 2-5 to pair the next handset.
Remove a WHS
To delete an already paired handset:
1 Select REMOVE A WHS from the WIRELESS HANDSET submenu.
2 Select the handset you want to remove, press the OK key, and select YES.
Locate a WHS
To locate an already paired wireless handset:
1 Select LOCATE A WHS from the WIRELESS HANDSET submenu.
2 Use and to select the handset you wish to locate.
3 Press OK. The handset to be located will commence beeping for 30 seconds if it is turned ON within
the wireless range.
Congure WHS audio
You can select an option to repeat the audio between the WHS and the host radio.
¼ Note: In some situations, this can result in audio feedback if the wireless handset is too close to the
host radio’s speakers.
Repeat WHS audio
Select to repeat the wireless handset audio on the host radio.
Repeat Host Radio audio
Select to repeat the host radio audio on the wireless handset.
Congure handset
Select CONFIGURE HANDSET in the menu to assign a name of your handset.
1 Use and to select the handset you want to name and press OK.
2 Enter the handset name. To enter a character, refer to “Entry of alphanumeric data” on page 12.
3 Press DSC/MENU to save the name.
Using the wireless handset
Turning the wireless handset ON/OFF
Long press the X key to turn ON the wireless handset. The handset will display the wireless handset’s
software version and then attempt to reconnect with the host radio. Once connected, use the wireless
handset in the same way as you would be using a fixed handset.
32 |
Radio menus | RS100 / RS100-B / V100 / V100-B User Manual

Navico Simrad RS100 Specifications

General

Brand	Navico
Model	Simrad RS100
Category	Receiver
Language	English