3-2 Chapter 3: Hardware Installation
Mounting Options
The 5965 has a VESA standard 75mm mounting pattern on the back of the enclosure. The unit
is shipped with mounting screws installed.
5965 Cables Connecting to a POS
The following illustrations show the cable connections for the 5965 and a host terminal. There
are two cables required.
DVI or VGA cable for video
Powered Universal Serial Bus (USB) for data and power
Note: Optional Power Brick is available when USB power is not available on the host
terminal. A special USB cable is used for data in this case.
If audio is used, connect the Audio Connector on the 5965 to the Audio Out port on the
host computer through the 0.9 m (3 ft.) or 4.6 m (15 ft.) Audio cable.
There are standard USB ports (1-3) on the 5965 that can be used for additional USB
devices.
To Next Page
Loading...