3
Chapter 3: Touch Screen Calibration
Note: This chapter discusses calibration procedures using Hampshire, Version 6.31gs.
Installing and Calibrating the Touch Screen
Be sure to observe for the following Touch Screen calibration guidelines:
Calibrate the touch screen as part of the installation process.
Recalibrate the touch screen when the system is installed at its final location.
Recalibrate whenever the terminal is moved to a new location.
Recalibrate the touch screen anytime the system has been disassembled for servicing.
Download the Calibration software from the NCR website.
http://www.ncr.com
a. At this site, select Support.
b. Under Related Items, Services; select Drivers and Patches → Retail Support
Files → NCR RealPOS and SelfServ Peripherals → Displays → 5965.
c. Download the Microchip Driver.
Installing the Driver
Note: If you have a previous version of another touch screen driver loaded on your system
you must completely remove it using the Control Panel Add/Remove program before
continuing with this installation process. Even though there is a message that it is not
necessary do perform a System Restart after removing the old driver.
1. Extract the driver installation files into to a working directory on the POS terminal.
2. Run the Setup.exe program from this directory.
3. Welcome screen > Next
4. License Agreement screen > Accept, Next
To Next Page
Loading...