NCR RealPOS 50 - Installing a Customer Display; Using the Peripheral Integration Tray; Using the Table Top Stand

Hardware Installation 2-15
Installing a Customer Display
Thecustomerdisplayscanbeeitherintegratedwiththeterminalorinstalledremotely. 
Thisdocumentdescribeshowtoinstallthedisplaysremotely.
ThedisplayscanbeintegratedusingthePeripheralIntegrationTrayoronthebottom
oftheTableTopStandusingtheCustomerDisplayBase.Illustrationsofthese
configurationsareshownintheCustomerDisplayssectioninChapter1.
Forinstallationinformationaboutintegratingthedisplaysseetheassociatedkit
instructionsfortheconfigurationbeinginstalled.
Using the Peripheral Integration Tray
•PeripheralIntegrationTray(7610‐K304)
Using the Table Top Stand
AdditionalkitsarerequiredtoinstallthedisplayontheTableTopStand,depending
onthetypeofdisplay.IfinstallinganLCDdisplaythefollowingarerequired.
•CustomerDisplayBase(7610‐K304)
•DCustomerDisplayTiltMount(7610‐K453)
Ifinstallinga59752x20displaythefollowingarerequired.
•CustomerDisplayBase
(7610‐K304)
•Display4/8ʺPole(5975‐K834)orDisplay12/16ʺPole(5975‐K836)