NCR RealPOS 50 - Interface (Powered)

Hardware Installation 2-29
5. RoutetheInterfaceCablethroughthePost
6. AssemblethePostcomponents.
7. ConnecttheDisplayCabletotheterminal.
RS-232 Interface (Powered)
ConnecttheI/FcabletoapoweredRS‐232connectorontheterminal.
Note: ThefactorydefaultsettingsfortheCOM1andCOM2portsarepoweredby
default.Tochangeaporttonon‐poweredseethePoweredSerialPortappendix.
Configuretheterminalserialportasfollows:
9600 baud, 8 data bits, 1 start bit, 1 stop bit, No parity
22910
Display Swivel
Raised extension faces the
front of the display.