NCR RealPOS 50 - Page 76

2-28 Hardware Installation
1. LocatetheDisplayMountwithin4meters(13ft.)ofthehostterminal.
2. Determineifthecableshouldberouteddownthroughthemountingsurfaceorifit
shouldberunontopofthesurface.Drillaholeifnecessary.
3. Ifyouareinstallingwithapostgreaterthan215mm
(8.5in.)securetheBasePlate
withscrews(4)thatareprovided.
4. ConnecttheInterfaceCabletotheDisplayModule.
a. Removethescrews(2)fromtheDisplayBack.
b. RemovetheDisplayBack.
c. RoutetheInterfaceCablethoughtheopeningintheDisplayBack.
d. ConnectthecabletotheproperconnectorontheDisplay
Module.
e. ReassembletheDisplayAssembly.
22930
22909
Display Front
Display Back
Display Module
USB Connector
RS-232 Connector