NCR RealPOS 50 - Installing a Secondary Display (Dual Display)

Hardware Installation 2-31
Installing a Secondary Display (Dual Display)
The7611MotherboardusesanintegratedvideocontrollerwiththeIntel945GSE
GMCHchipset.ThiscontrollerprovidesaMonitorport(VGA)andaDigitalDisplay
port(DVI)onthemotherboardconnectorrowfortheseconddisplay(DVIorVGA).
The7611displayusestheLVDSportandisalwaystheprimary
display.Thedriver
recognizesthisportasNotebook.TheDualdisplaymodecanbeaclone(samevideo
datadisplayedonbothdisplays)oranextendeddesktop(thedesktopspansacrossboth
displays).
ThedualmodeisconfiguredusingtheIntel®GraphicsMedia Acceleratorcontrolpanel.
1. Powerdownthesystem.
2. Connect
thesecondarydisplay.
Note: Bothdisplaysmustbeconnectedtothe7611beforepoweringupthesystem.
3. Applypowertothesystem.
Note: POSTDiagnosticsdonotdisplayonthesecondarydisplayifconnectedto
theDVIport.BothdisplaysfunctionproperlyafterWindowsisbooted.
4. RightclicktheDesktopandthenselect
GraphicsPropertiesfromthemenuto
startthecontrolpanel.Bothdisplaysshouldberecognized.