NCR RealPOS 50 - Calibration Procedures

Touch Screen Calibration 3-7
Calibration Procedures
Note: Inordertoachieveanaccuratecalibrationthetouchdisplaymustinthenormal
operatingpositionwhenACpowerisappliedtotheterminal(45degreescanbe
assumedifthisnotknown).IfthiswasNOTdoneproperlythenbeginwithStep1.
OtherwiseskiptoStep2.
1. Select
Start→Programs→Microchip TSHARC Control Panel.
Note: TheCalibrationprogramcanalsobestartedwiththeTouchiconatthe
bottomofthescreen.
2. SelecttheCalibrationTab.
3. Select9‐Pointw/Linearization.
4. SelecttheBeginLinearizationbutton.