NCR SelfServ 28 - Customer Responsibilities

NCR SelfServ 28 ATM Site Preparation
B006-6884-A000 3
NCR staff will be available to answer questions relating to the contents of this bookset but,
except where:
a the customer has been notified that a full or partial consultancy service is available
and/or that NCR will be willing to undertake a preliminary or final site survey and
b the customer shall have entered into a formal contract with NCR for provision of the
same
no comment, suggestion or advice offered or not offered about preparation of the site nor
any inspection of the site whether before or after preparation is to be taken as approval of
the location of the site and equipment or of its preparation and NCR will not be liable in
respect of any comment, suggestion or advice given by its staff or in respect of any failure
to give advice.
Finally, only the customer can know the full extent of damage which may be caused to his
business by reason of failure of the equipment which is to be installed. For this reason it is
the customer’s responsibility to ascertain the extent of any such possible damage to his
existing or planned business, and to effect, full insurance in respect of it.
Customer Responsibilities
The customer must do or provide the following:
 When required by NCR, provide the NCR customer service representative with
appropriate drawings that indicate:
 Location of the equipment
 Site wiring (power and signal, paths and lengths)
 Location of other equipment capable of generating electrical noise,
electromagnetic interference, heat, etc.
 Make building alterations necessary to meet wiring and other site requirements.
 Provide and install all communications cables, wall jacks, special connectors, and
associated hardware.
 Provide and install necessary power distribution boxes, conduits, grounds, lightning
protection, and associated hardware.
 Make sure all applicable codes, regulations and laws (including, but not limited to,
electrical, building, safety, and health) are met.
 Provide and install auxiliary power or other equipment as required.
 Provide storage or service areas as required.
 Make sure the environmental requirements of the system/unit are met.