NCR SelfServ 28 - Product Identification; ATM Location

NCR SelfServ 28 ATM Site Preparation
4 B006-6884-A000
 Provide floor coverings and environmental systems that limit or control static
electricity build-up and discharge.
 Install the product at a height which meets the accessibility regulations of the relevant
country.
Product Identification
The illustration below shows the layout of the product identification label which is fixed
inside the top-box of the ATM.
The product is identified by the class, 6628, and a 4 digit model number. The serial
number is unique to each ATM. The tracer number is used to identify where the ATM was
built.
Please quote all of the serial and tracer numbers, including the prefix, when making
reference to the ATM.
ATM Location
The ATM should be located in free draining area and in a position where bright sunlight
will not fall directly on the screen.
Model: XXXX
Hz: 50/60
A: X.X
XX - XXXXXXXX
Tracer:
Serial:
Vãc:
NCR Global Solutions Ltd.
NCR SelfServ 28
™
CUS
Made in UK
Electromagnetic Compatibility
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This apparatus does not exceed Class A limits for radio noise emissions set out in the Radio Interference
Regulations of Canada.
Complies with FDA Radiation Performance Standards, 21 CFR Subchapter J
Class: 6628
XX-XX
®
LR32207
ACN 000 003 592
Manufactured: Xxxxxx XXXX
XXX - XXXv
Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux
appareils numériques de la classe A prescrites dans le Réglement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada