Section 4: Optional Equipment
Aspila EX Hardware Manual Section 4: Optional Equipment 4-17
4
SYSTEM PHONE LABELING
Labeling Your Phone
The Aspila EX system phones can be easily labeled by removing the clear plastic faceplate on the sys-
tem phones. These labels can be printed by hand, typewriter, or by using the Aspila EX Labelmaker
program. Labels for this are on 8 1/2 x 11” paper, which allows for easy printing by any printer - dot
matrix, laser, etc.
Removing the Faceplate:
1. At the lower right-hand corner of the telephone, you’ll notice a small notch in the faceplate
plastic. Use this notch to help lift the faceplate up.
Each corner has a plastic locking pin which releases as the faceplate is lifted up.
If the faceplate is dropped, these pins may pop out of place. Be careful not to lose the pins.
Replacing the Faceplate:
1. Place the faceplate back on the phone.
2. At each corner, press the locking pin back into place.
To Next Page
Loading...
