Section 2: PCB Installation and Startup
2-40 Section 2: PCB Installation and Startup Aspila EX Hardware Man-
In-Skin Server/Router (APSU) PCB (Figure 2-17)
The In-Skin Server/Router PCB provides server functionality within the Aspila EX system with a hard
drive or IDE flash memory. The hard disk or IDE flash memory can provide an operating system and
application software ability which can be used with CTI applications. The In-Skin/Server/Router PCB
provides:
• Status LED
• HDD LED for HDD access
• Power monitor LED
• Server status LED
• PCMCIA card slot
• Run/Block switch
• Server reset switch (used to reset the server when necessary)
• CRT connector
• WAN connector
• RJ-45 LAN connector
• PS/2 mouse connector
• PS/2 keyboard connector (keyboard required for maintenance purposes only)
• 44-pin connector for 2.5” HDD or IDE flash memory connection
• 10-pin connector for an external unit with a serial interface
• 6-pin connector for an external unit with a USB interface
The system allows 1 PCB per system. This can be plugged into any universal slot.
! Important !
Do not remove this PCB with the power on.
To Next Page
Loading...
