Section 4: Optional Equipment
Aspila EX Hardware Manual Section 4: Optional Equipment 4-39
4
WALL-MOUNT BRACKET
Using the Wall-Mount Bracket
Each Aspila EX phone has an integrated wall-mounting bracket. This allows the phone to be mounted
to a wall at a convenient location. The mounting bracket also contains the hookswitch hanger, clipped
to the inside of the bracket.
Note. Telephones with any optional adapters installed cannot be wall-mounted. The bracket will not
accommodate the adapter(s).
Installing the Wall-Mount Handset Bracket (Figure 4-44 - Figure 4-46)
1. Remove the integrated wall bracket from the bottom of the phone. Refer to Figure 4-44.
- From the center cut-out, pull the bracket up and out.
2. Remove the wall-mount hookswitch tab located on the bracket by gently pulling the locking
lever down slightly while lifting the tab out (Figure 4-45).
3. Insert the wall-mount hookswitch tab in the slot below the hookswitch (Figure 4-46).
Figure 4-44: REMOVING THE WALL-MOUNT BRACKET
To Next Page
Loading...
