Section 2: PCB Installation and Startup
Aspila EX Hardware Manual Section 2: PCB Installation and Startup 2-51
2
Initial Programming (Figure 2-22)
The system can be programmed using three methods:
• Programming through a digital system phone with LCD display
• PC Programming
Refer to the PCPro/WebPro Installation Manual, for complete installation details.
• Web Programming
Refer to the PCPro/WebPro Installation Manual, for complete installation details.
Refer to the Aspila EX Software Manual for complete details on programming.
Entering the Programming Mode
Enter the system programming mode at any system phone with an LCD display:
1. Press CALL1. (You hear dial tone).
2. Dial # * # *.
3. Dial the system password.
4. Press HOLD.
The system allows up to two people to be in program mode at one time. If both program-
mers are making entries to the same program, the system will accept the entries made by the
last person in that program.
Port Defaults
With the default settings, the ports are assigned as follows:
Figure 2-22: TELEPHONE KEY LAYOUT
Password Level
12345678 2 (IN)
0000 3 (SA)
9999 4 (SB)
Station Ports: 1-512 (ports 1-300 = extensions 200-499)
Virtual Station Ports: 1-256 (extensions not assigned)
Trunk Ports: 1-200
To Next Page
Loading...
