Section 2: PCB Installation and Startup
Aspila EX Hardware Manual Section 2: PCB Installation and Startup 2-1
2
Section 2:
PCB Installation and Startup
Section 2: PCB Installation and Startup
PCB LAYOUT
PCB Location
Determine the slot position for each PCB in the Main Cabinet:
• CPU/EXP slot - dedicated for the NTCPU
• Slot 1-8 are universal (any type of PCB can be installed).
In the Expansion Cabinet:
• CPU/EXP slot - dedicated for the Expansion PCB
• Slots 9-16 are universal (any type of PCB can be installed).
Use the table below to determine the PCB for each slot.
EXIFU
9 10111213141516
NTCPU
12345678
Important Notes
• Make sure to follow the steps indicated in Powering up the System (page 2-50) for an initial
system install. This will ensure that you start the system with the default system settings.
• To delete a PCB from the system, the PCB must first be removed from the system slot, then
Program 90-05-01 can be used to delete the slot definition.
To Next Page
Loading...
