Section 2: Components
Product Description 15
2
Trunk PCBs
4 CO Loop Start Trunk Card (4COIU-LS1) — P/N 0891005
There are two different types of the COIU PCB. One providing ground start trunks - the other is for
loop start trunks only.
The 4COIU-LS1 PCB provides:
● 4 analog loop start line/trunk circuits - no ground start is provided
● 4 trunk status LEDs
● 4 Caller ID Circuits
● 2 Power Failure Transfer Circuits
● 1 PCB status LED
● 1 run/block switch
The CN3 connector provides connection to 4 analog trunk ports, which are polarity sensitive (tip to
tip, ring to ring). The power failure circuits, however, are not polarity sensitive. A maximum of 15
4COIU-LS1 PCBs per system is allowed.
! Important!
● When connecting the RJ61 cables to the COIU PCB, note the position of the Power Failure
connector. Do not confuse this connector as the trunk connector.
8 CO Loop Start Trunk Card (8COIU-LS1) — P/N 0891004
The 8COIU-LSI provides the same features as the 4COIU-LS1 except for the following changes:
The 8COIU-LS1 PCB provides:
● 8 analog loop start line/trunk circuits - no ground start is provided
● 8 trunk status LEDs
● 8 Caller ID Circuits
● 2 Power Failure Transfer Circuits
● 1 PCB status LED
● 1 run/block switch
The CN3 and CN5 connectors each provide connection to 4 analog trunk ports, which are polarity
sensitive (tip to tip, ring to ring). The power failure circuits, however, are not polarity sensitive. A
maximum of 15 8COIU-LS1 PCBs per system is allowed.
! Important!
● When connecting the RJ61 cables to the COIU PCB, note the position of the Power Failure
connector. Do not confuse this connector as the trunk connector.
To Next Page
Loading...
Need help?
General
