NEC DT820 - DT820 Directory Operation and Management

111
3. Dial the Station Speed Dial buffer number to be
programmed (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
0 = Station Speed Dial buffer 10
4. Dial the Access Code (e.g., 9) – if required.
5. Dial telephone number you want to store (up to 24
digits).
Note: Valid entries are 0~9, # and *. To enter a pause,
press MIC. To store a Flash, press Recall.
6. Press Hold.
7. Enter the name associated with the Speed Dialing
number (display telephones only):
Use this
keypad
digit....
Key for Entering Names
When you want to....
1 Enter characters:
1 @ [ ¥ ] ^ _ ` { | } Æ
¨ Á À Â Ã Ç É Ê ì ó
2 Enter characters: A-C, a-c 2
3 Enter characters: D-F, d-f, 3
4 Enter characters: G-I, g-I, 4
5 Enter characters: J-L, j-l, 5
6 Enter characters: M-O, m-o, 6
7 Enter characters: P-S, p-s, 7
8 Enter characters: T-V, t-v,8
9 Enter characters: W-Z, w-z,9
0 Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú ä ö ü á å è
* Enter characters:
+ , - . / : ; < = > ? B E ó S ¢ £
# # = Accepts an entry (only required if
two letters on the same key are
needed – ex: TOM). Pressing # again
= Space.
Conf Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Name).
Exit Clears all the entries from the point of
the flashing cursor and to the right
(used when entering the Number, this
clears both the number and name).