NEC DT820 - Exclusive Hold; Holding Calls; System Hold; Transferring Calls

92
Holding Calls
System Hold –
With a call in progress:
1. Press Hold.
Exclusive Hold –
With a call in progress:
1. Press the Exclusive Hold key (Service Code
751:45).
-OR-
Press the Feature key then Hold key.
Note 1:
To retrieve a held call, press the flashing Line
key or ICM key (Internal calls).
Note 2: Calls on System Hold can be retrieved from
any multiline terminal with the held line
appearance.
Note 3: After a preprogrammed time, the held call will
recall to the originating station.
Transferring Calls
Using Manual Dial –
With a call in progress:
1. Press the Transfer key.
2. Dial the station number.
3. Announce the call (optional).
4. Replace the handset.
Using Direct Station Selection (DSS) –
With a call in progress:
1. Press the Transfer key.
2. Press the programmed DSS.
3. Announce the call (optional).
4. Replace the handset.
Note 1:
If the called station is busy, replace the
handset to initiate a camp-on. Unanswered
camp-on calls and unscreened transfers will
recall to the transferring station.
Note 2: To return to the original party, press the
flashing Line key or Conf key.
Note 3: A Programmable Function Key may be
assigned for DSS.
Note 4: To transfer a call directly to a personal voice
mailbox, dial 8 after dialing the station
number.
HOLD STA 12345678
2-13 WED 5:40PM
VMsg
InPg ExPg

HOLD STA 12345678
2-13 WED 5:40PM
VMsg InPg ExPg
