NEC DT820 - 3 Basic Operation; Basic Operation; Login; Logout

85
3. BASIC OPERATION
Login
When login mode is activated, the following procedure
is required.
1. Enter login code and press the Set softkey.
2. Enter the password and press OK softkey.
If the login code is accepted, display changes to
normal idle status.
Logout
1. Press the preassigned Logout Feature Key on the
terminal.
Note:
This location is an example.
Note: Logout button is assigned by data setting at
the ECP (Enterprise Communication
Platform).
2. “LOGOUT?” is displayed on the LCD of the
terminal.
3. Press the Logout Feature Key on the terminal
again.
Password
Login ID 2000
:
:
Cancel BK Set OK
Login ID 2000
:
Cancel BK Set OK
*****
Password
:
28 APR MON 8:45AM
List Dir VMsg

101
STA 101
28 APR MON 8:45AM
List Dir VMsg

101
STA 101
L-OUT
28 APR MON 8:45AM
LOGOUT ?
101
STA 101