1.6
Get ready to go
e616V
Get ready to go
1.5
e616V
Battery use
Battery performance depends
on many factors, including
signal strength, the features
and / or settings you select
and use, and your voice,
data and other application
usage patterns.
Battery care
To prevent injuries or burns,
do not allow metal objects to
contact or short-circuit the
battery terminals.
To maximise your
battery’s performance
Always use NEC Original™
batteries and battery chargers.
NEC’s handset warranty does
not cover damage caused from
using non-NEC batteries and /
or battery chargers.
New batteries or batteries that
have been stored for long
periods of time may require
a longer charge time.
Maintain the battery at or
near room temperature
when charging.
If you don’t intend to use the
battery for a long period of
time, remove it from the
handset and store it in a
place with low humidity
and low temperature.
Over extended periods of time,
batteries gradually degrade
and require longer charging
times. This is normal. If you
charge your battery regularly
and notice a decrease in talk
time or an increase in charging
time, then it’s probably time to
buy a new battery.
The rechargeable batteries that
power your handset must be
disposed of properly and may
need to be recycled. Refer to
your battery’s label for battery
type. Contact your local
recycling centre for proper
disposal methods. Never
dispose of batteries in a fire
because they may explode.
Extending battery life
● Turn off your handset
screen’s backlight
The backlight uses power.
To turn it off, see page 3.6.
● Avoid the Vibrate
ring setting
Your handset’s Vibrate
setting uses more power
than a standard ring sound
or the Silent setting.
To change alert profiles,
see page 3.7.
Installing a memory card
Your handset can support a Memory Stick Duo™ (memory card) with up to 128MB.
You can use this memory
card to store photos, videos
or audio, calendars, To Do
entries and contact entries
(as vCard files).
Please read important
instructions on the memory
card in Section 10 – NEC’s
health and general safety
information.
How to install
the memory card
Always switch off the handset
before inserting or removing
the memory card.
Push the memory card fully
into the Memory Stick Duo™ slot
on the side of your handset,
as shown below.
How to remove
the memory card
1 Push the memory card into
the slot. This will release the
card from the slot.
2 Carefully pull the memory
card out of the slot.
How to format
the memory card
Before you can use the
memory card, you need
to format it:
1 Press
2 Scroll to
3 Scroll to
Memory Card Tool
4 At Format mem. card
press
5 Press
Yes
Formatting the memory card
will erase all previously
stored data.
To Next Page
Loading...
