3. Installing Windows Server 2022
Installation Guide (Windows Server 2022)
38
Chapter 1 Installing Windows
3.4
Setup of Device Drivers
Install and set up device drivers provided for the standard configuration of the server.
For details regarding the installation and setup of a driver for an optional device, refer to the manual supplied
with the optional device.
3.4.1
Installing the LAN drivers
(1)
LAN drivers
The drivers are installed by Standard Program Package.
Important
Wake On LAN (WOL) is supported by N8104-207 only.
Wake On LAN is available after installing the LAN driver.
BIOS settings, check Maintenance Guide.
Note
To change the LAN driver settings, sign in to the system from a local console
using an administrator’s account. Remotely changing the settings by using the
operating system’s remote desktop feature is not supported.
Choose the Internet Protocol (TCP/IP) check box when specifying an IP
address.
(2)
Optional LAN board
This server supports the following optional LAN boards.
R120i-1M
R120i-2M
N8104-207/210/211
If you install the LAN boards after installing Standard Program Package, install Standard Program Package
again according to Chapter 1 (3.3 Standard Program Package Installation).
To Next Page
Loading...
Need help?
General
