NEC Express5800 Series Installation Guide

3. Installing Windows Server 2022
Installation Guide (Windows Server 2022)
40
Chapter 1 Installing Windows
(2)
Configuring Flow Control
Flow Control is a feature to stop transmitting frames temporarily by sending a pause frame to the destination
device when the receive buffer is about to run out. When it receives a pause frame, it regulates the
transmission.
Configure the Flow Control following the procedure below
Tips
The settings of Flow Control of the network adapter should match those of the
destination device. For example, if Flow Control in the destination device is set as
Enabled, that in the network adapter should be set as Enabled.
1. Open the Device Manager.
2. Expand Network Adapters, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
3. Open Advanced tab, click Flow Control to show Value.
4. The Value can be changed by the down-arrow button.
5. Click OK, and then restart the system.
The Flow Control setting is now complete.
3.4.3
Using Graphics Accelerator
For installation with the Manual installation, the drivers are installed by Standard Program Package.
If you install the Graphics Accelerator driver after installing Standard Program Package, install Standard
Program Package again according to Chapter 1 (3.3 Standard Program Package Installation).
3.4.4
Using SAS Controller (N8103-184/E184)
The driver for SAS controller N8103-184/E184 is automatically installed by Windows Plug-and-Play.
3.4.5
Using SAS Controller (N8103-197)
For installation with the Rapid Setup or Manual installation, the drivers are installed by Standard Program
Package.
If you install the SAS controller (N8103-197) after installing Standard Program Package, install Standard
Program Package again according to Chapter 1 (3.3 Standard Program Package Installation).
3.4.6
Using RAID Controller (N8103-189/190/191/192/193/194/195/201/237/238)
For installation with the Manual installation, the drivers are installed by Standard Program Package.
If you install the RAID controller (N8103-189/190/191/192/193/194/195/201/237/238) after installing
Standard Program Package, install Standard Program Package again according to Chapter 1 (3.3 Standard
Program Package Installation).

NEC Express5800 Series Specifications

General

Series	Express5800
Category	Server
Processor	Intel Xeon processors
Network	Gigabit Ethernet, 10 Gigabit Ethernet (Varies by model)
Operating System Support	Windows Server, Linux variants
Form Factor	Tower, Rackmount (1U, 2U, etc. - varies by model)
Memory	DDR4 ECC DIMM (Capacity varies by model)
Storage	SAS/SATA HDD/SSD, NVMe SSD (Configuration varies by model)