NEC Express5800 Series - Setting up LAN Drivers

3. Installing Windows Server 2022
Installation Guide (Windows Server 2022)
39
Chapter 1 Installing Windows
(3)
Network adapter name
After installing the LAN drivers, the following network adapter names will be displayed on the Device
Manager.
- If connecting with an optional LAN board:
N8104-207 Marvell FastLinQ Ethernet 10Gb 2-port BaseT QL41132HQRJ OCP3 Adapter #xx(*1)
N8104-210 Marvell FastLinQ Ethernet 10Gb 2-port BaseT QL41132HLRJ Adapter #xx(*1)
N8104-211 Marvell FastLinQ Ethernet 10/25Gb 2-port SFP28 QL41232HLCU Adapter #xx(*1)
*1: If there are adapters with the same name, a different identification number will be assigned to xx.
Tips
The ID for N8104-207/210/211 might be a number of two or more digits.
This is due to the LAN driver specifications and not an error.
This number cannot be changed.
Tips
The network adapter name displayed in the device manager may be different from
the one listed above. In this case, the correct network adapter name can be
displayed by following the procedure below.
1. Start Device Manager.
2. Open Network Adapters, right click on the relevant adapter, and select
Uninstall Device.
Do not check the Delete the driver software of this device checkbox.
3. Select Scan hardware change from Control.
3.4.2
Setting up LAN drivers
(1)
Setting link speed
The transfer rate and duplex mode of the network adapter must be the same as those of the switching hub.
Follow the procedure below to specify the transfer rate and duplex mode.
1. Open the Device Manager.
2. Expand Network Adapters, and then double-click the name of the network adapter you want to
configure.
The properties of the network adapter will be displayed.
3. On the Advanced tab, set the Speed & Duplex values to the same as those of the switching hub.
Tips
When using the N8104-207/210/211, Link control set to Driver controlled.
*When Link control is Preboot controlled, link speed setting of BIOS take a
priority.
4. Click OK in the Network Adapter Properties dialog box.
5. Restart the system.
The link speed setting is now complete.