5-10
Problem Solving
Table 5-1. POST Keys and Errors
ACTION/MESSAGE DESCRIPTION
If POST Beeps Before
Video Appears
Initialization failed before video initialized. Most beep code errors are
fatal; initialization cannot continue. Refer to the section
BIOS User’s
Information
in this chapter.
If Monitor Displays Error Note error; press F1 to continue boot or F2 to enter Setup. Refer to
the section
BIOS User’s Information
in this chapter.
To Enter Setup Use Setup utility before using Resource Configuration Utility (RCU)
to configure entire system. Setup changes specific options, then
writes to CMOS, NVRAM. Press F2 during initialization to run Setup.
If you do not press F2, the boot process continues.
POST Beeps Initialization has completed.
Enter BOOT Diskette If prompted, insert the boot diskette.
To Next Page
Loading...
