4-22
Upgrades and Options
Hard Disk Drives
The system supports a variety of SCSI devices. Contact
your sales representative or dealer for a list of approved
devices. The internal hard disk drives are located in the
3.5-inch drive bay (Figure 4-9, A).
Notice: The system uses single-ended SCSI host
adapter and devices. Failure to install single-ended
SCSI drive types can result in electrical damage to the
host adapter and the peripherals.
Notice: The “Terminator Enable” jumper must be
installed in the last hard disk drive of the daisy chain
cabling (top drive bay 1, SCSI ID = 0). The SCSI
terminators must be removed from all other drives.
Figure 4-9. 3.5-Inch Drive Bay Locations
A
1
2
3
4
SCSI ID ASSIGNMENT
BAY DEVICE ADDRESS
1 First Hard Disk 0
2 Second Hard Disk 1
3 Third Hard Disk 3
4 Fourth Hard Disk 4
To Next Page
Loading...
