NEC LE2200 - RCU Configuration Settings

3-6
Configuring Your System
RCU Configuration Settings
Table 3-3 shows the RCU settings for a sample system
and provides a place for you to record any changes you
make to the settings. To display the configuration
settings, select Step 3 under the Resource Configuration
Utility Menu. To edit any of the configuration
parameters, use the up and down arrows to highlight
the desired configuration parameter and press ENTER.
Pressing F6 at this point, allows you to edit any of the
parameters resources (IRQs, DMAs, I/O ports or
memory).
Table 3-3. RCU Configurations
MAIN MENU NORMAL SETTING YOUR CONFIGURATION
System Board
Mouse Controller Enabled
RS - 232 COMM Port 1 PORT 3F8h - 3FFh IRQ 4
RS - 232 COMM Port 2 PORT 2F8h - 2FFh IRQ 3
Parallel Port PORT 378h - 37Fh IRQ 7
IDE Controller Enabled
Floppy Controller Enabled
SLOT 1 - PCI Ethernet Controller
PCI Function 1 Enabled
Embedded - PCI SCSI Controller
PCI Function 1 Enabled
Embedded - PCI SCSI Controller
PCI Function 1 Enabled
Embedded - PCI VGA Controller
PCI Function 1 Enabled
Standard VGA Resources Enabled