4-9
Upgrades and Options
1. Power off the system and remove the side panel as
described earlier in this chapter.
2. Using your finger nail or a small pointed tool, gently
push down the top of the battery and pry up the
battery out of its socket. Refer to Figure 4-4 for the
socket location.
3. Orient the new battery over its socket so the plus (+)
sign on the battery is facing up.
4. Carefully insert the bottom of the battery into the
socket connectors and gently push the battery into
the socket.
5. Press down on the battery until it is firmly seated in
its socket.
6. Replace the side panel and turn on the system.
7. Run the RCU to restore configuration settings to the
real-time clock.
Pentium II Processor
The following subsections provide procedures for
upgrading and configuring the processor in your system.
Topics covered include:
■ Adding a Pentium II processor
■ Removing a Pentium II processor.
Notice:
Electrostatic discharge (ESD) can damage
components; place them on an antistatic surface. Modify
the system board using an antistatic wrist strap
attached to chassis ground.
To Next Page
Loading...
