NEC MultiSync FP1350 - Page 73

5-32
b-4. As following menu E appear on monitor screen, select “H. SIZE” and push “RETURN” key.
(Menu E)
b-5. As following menu F appear on monitor screen, push “5” key.
Then adjust data value to 255 by pushing one of “3”, “6” and ”9” keys.
Note: If screen is over scanned by smaller value than 255, push “RETURN” key to end
“H. SIZE” adjustment.
Then select “5 : H. SIZE(MAX)” and decrease horizontal
size, and set up data value to 255 at “H. SIZE”
adjustment procedure.
In this case, you must be careful not to decrease horizontal size too small at “5 : H. SIZE(MAX)”
adjustment.
(Menu F)
Size/Position Adjust MODEL:
FP1350-1
SIGNAL :H_MAX
1 : H. POSI
2 : V. POSI
3 : H. SIZE
4 : V. SIZE
5 : H. SIZE(MAX)
6 : END
Size/Position Adjust MODEL:
FP1350-1
SIGNAL :H_MAX
1 : H. POSI
2 : V. POSI
3 : H. SIZE
4 : V. SIZE
5 : H. SIZE(MAX)
6 : END
No. ?
DAC VALUE: 120
Decrease : 1(-1), 4(-5), 7(-10) Increase : 3(+1), 6(+5), 9(+10) Original : 5
END(NO WRITE) : e E END(WRITE) : ENTER