NEC NP610 - Battery Installation; Remote Control Precautions; Operating Range for Wireless Remote Control

10
1. Introduction
Remote Control Precautions
• Handletheremotecontrolcarefully.
• Iftheremotecontrolgetswet,wipeitdryimmediately.
• Avoidexcessiveheatandhumidity.
• Donotheat,takeapart,orthrowbatteriesintore.
• Ifyouwillnotbeusingtheremotecontrolforalongtime,removethebatteries.
• Ensurethatyouhavethebatteries’polarity(+/−)alignedcorrectly.
• Donotusenewandoldbatteriestogether,orusedifferenttypesofbatteriestogether.
• Disposeofusedbatteriesaccordingtoyourlocalregulations.
Operating Range for Wireless Remote Control
1
Press firmly and slide the battery
cover off.
2
Installnewbatteries(AAA).Ensure
that you have the batteries’ polarity
(+/−)alignedcorrectly.
• Theinfraredsignaloperatesbyline-of-sightuptoadistanceofabout22feet/7mandwithina60-degreeangleof
the remote sensor on the projector cabinet.
• Theprojectorwillnotrespondifthereareobjectsbetweentheremotecontrolandthesensor,orifstronglightfalls
onthesensor.Weakbatterieswillalsopreventtheremotecontrolfromproperlyoperatingtheprojector.
Battery Installation
30°
30°
30°
30°
7 m/22 feet
7 m/22 feet
Remote control
Remote sensor on projector cabinet
3
Slipthecoverbackoverthebat-
teriesuntilitsnapsintoplace.Do
not mix different types of batteries
ornewandoldbatteries.
Remote control