EasyManua.ls Logo

NEC NP610 - Changing Eco Mode

NEC NP610
115 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
41
4. Convenient Features
Changing Eco Mode
Thisfeatureenablesyoutoselecttwobrightnessmodesofthelamp:
OFFandONmodes.Thelamplifecanbeextendedbyturningonthe[ECOMODE].
[ECOMODE] Description StatusofLAMPindicator
[OFF] Thisisthedefaultsetting(100%Brightness). Off
STATUS
LAMP
[ON] Select this mode to increase the lamp life (approx.
70%Brightnesson NP610/NP510W/NP410W/
NP610S/NP510WSandapprox.80%Brightnesson
NP510/NP410/NP405/NP310/NP305).
Steady Green light
STATUS
LAMP
Toturnonthe[ECOMODE],dothefollowing:
1. Press the ECO MODE button on the remote control to display [ECO MODE] screen.
2. Use the or button to select [ON].
3. Press the ENTER button.
Tochangefrom[ON]to[OFF],GobacktoStep2andselect[OFF].RepeatStep3.
NOTE:
• The[ECOMODE]canbechangedbyusingthemenu.
Select[SETUP][GENERAL][ECOMODE].
• Thelampliferemainingandlamphoursusedcanbecheckedin[USAGETIME].Select[INFO.][USAGETIME].
• Theprojectorisalwaysin[ON]for90secondsafterthelampisturnedonandwhilethePOWERindicatorisblinkinggreen.The
lampconditionwillnotbeaffectedevenwhen[ECOMODE]ischanged.
• Afteralapseof1minutefromwhentheprojectordisplaysablue,blackorlogoscreen,[ECOMODE]willautomaticallyswitchto
[ON].Theprojectorwillreturntothe[OFF]onceasignalisaccepted.
• Iftheprojectorisoverheatedin[OFF]mode,theremaybeacasewherethe[ECOMODE]automaticallychangesto[ON]mode
toprotecttheprojector.Whentheprojectorisin[ON]mode,thepicturebrightnessdecreases.Whentheprojectorcomesback
tonormaltemperature,the[ECOMODE]returnsto[OFF]mode.
Thermometer symbol [ ]indicatesthe[ECOMODE]isautomaticallysetto[ON]modebecausetheinternaltemperatureistoo
high.
2. Press the  button.
The area of the magnified image will be moved
3. Press the MAGNIFY (−) button.
Each time the MAGNIFY (−) button is pressed, the image is re-
duced.
NOTE:
• Theimagewillbeenlargedorreducedatthecenterofthescreen.
• Displayingthemenuwillcancelthecurrentmagnication.
ENTER
EXIT
MENU
UP
MAGNIFY PAGE
OFF
POWER
ON
AV-MUTE
DOWN

Table of Contents

Other manuals for NEC NP610

Related product manuals