NEC NP610 - Connecting the Supplied Power Cable

25
2. Installation and Connections
Connecting the Supplied Power Cable
Connectthesuppliedpowercabletotheprojector.
Firstconnectthesuppliedpowercable’stwo-pinplugtotheACINoftheprojector,andthenconnecttheotherplug
ofthesuppliedpowercableinthewalloutlet.
CAUTION:
Donottrytotouchtheventilationoutletontheleftfront(whenseenfromthefront)asitcanbecomeheatedwhile
the projector is turned on and immediately after the projector is turned off.
MEN
U
EXI
T
ENTER
STATUS
LAMP
AUT
OAD
J. SOU
RCE
FOC
US
Makesurethattheprongsarefullyinsertedintoboth
the AC IN and the wall outlet.
To wall outlet ←