NEC NP610 - Connecting Your DVD Player with Component Output

22
2. Installation and Connections
Connecting Your DVD Player with Component Output
 Acomponentsignalwillbeautomaticallydisplayed.Ifnot,fromthemenu,select[SETUP]→[OPTIONS(1)]→
[SIGNALSELECT]→[COMPUTER1],andthenplaceacheckmarkintheComponentradiobutton.
• Selectthesourcenameforitsappropriateinputconnectorafterturningontheprojector.
[NP610/NP510/NP410/NP310/NP510W/NP410W/NP610S/NP510WS]
Inputconnector
SOURCEbuttonontheprojector
cabinet
Buttonontheremotecontrol
COMPUTER1IN COMPUTER1 (COMPUTER1)
COMPUTER2(DVI-I)IN COMPUTER2(ANALOG) (COMPUTER2)
[NP405/NP305]
Inputconnector
SOURCEbuttonontheprojector
cabinet
Buttonontheremotecontrol
COMPUTER1IN COMPUTER1 (COMPUTER1)
COMPUTER2IN COMPUTER2 (COMPUTER2)
NOTE:RefertoyourDVDplayer’sowner’smanualformoreinformationaboutyourDVDplayer’svideooutputrequirements.
AUDIOIN
L R
AUDIOOUT
L R
Component
Y Cb Cr
COMPUTER1IN
AUDIOIN
Audio cable (not supplied)
15-pin - to - RCA (fe-
male) × 3 cable adapter
(ADP-CV1E)
Component video RCA × 3
cable (not supplied)
DVD player
Audio Equipment