NEC NP610 - After Use

39
3. Projecting an Image (Basic Operation)
 After Use
Preparation:Makesurethattheprojectoristurnedoff.
1. Unplug the power cable.
2. Disconnect any other cables.
3. Retract adjustable tilt foot if extended.
4. Cover the lens with the lens cap.
5. Put the projector and accessories in the supplied soft case.
Place the projector in the soft case with the lens facing upward as shown below. This is to prevent the lens from
damage.
NOTE:TheNP610S,theNP510WS,theNP405,andtheNP305donotcomewithasoftcase.
NOTE:Whenplacingtheprojectorinthesoftcase,retractthetiltfootandtherearfeet.Failuretodosomaycasedamagetothe
projector.
CAUTION:
Usecautionwhenputtingtheprojectorinthesoftcaseimmediatelyaftertheprojectorhasbeenoperating.The
projector cabinet is hot.
Insert the projector with the lens
facing upward