NEC NP610 - Appendix; Troubleshooting and Indicators

77
5. Using On-Screen Menu
TurningOntheProjectorByApplyingComputerSignal[AUTOPOWERON(COMP1)]
WhentheprojectorisinStandbymode,applyingacomputersignalfromacomputerconnectedtotheCOMPUTER1
INinputwillpowerontheprojectorandsimultaneouslyprojectthecomputer’simage.
ThisfunctionalityeliminatestheneedtoalwaysusethePOWERbuttonontheremotecontrolortheprojectorcabinet
topowerontheprojector.
Tousethisfunction,rstconnectacomputertotheprojectorandtheprojectortoanactiveACinput.
NOTE:
• Disconnectingacomputersignalfromthecomputerwillnotpowerofftheprojector.Werecommendusingthisfunctionincom-
binationoftheAUTOPOWEROFFfunction.
• Thisfunctionwillnotbeavailableunderthefollowingconditions:
- whenacomponentsignalisappliedtotheCOMPUTER1INconnector
- whenaSynconGreenRGBsignalorcompositesyncsignalisapplied
• ToenabletheAUTOPOWERON(COMP1)afterturningofftheprojector,wait3secondsandinputacomputersignal.
 Ifacomputersignalisstillpresentwhentheprojectoristurnedoff,theAUTOPOWERON(COMP1)willnotworkandtheprojector
remains in standby mode.
EnablingPowerManagement[AUTOPOWEROFF]
Whenthisoptionisselectedyoucanenabletheprojectortoautomaticallyturnoff(attheselectedtime:5min.,10min.,
20min., 30min.) if there is no signal received by any input or if no operation is performed.
SelectingDefaultSource[DEFAULTSOURCESELECT]
Youcansettheprojectortodefaulttoanyoneofitsinputseachtimetheprojectoristurnedon.
LAST ...................................Sets the projector to default to the previous or last active input each time the projector is turned
on.
AUTO
..................................Searches for an active source in order of COMPUTER1 → COMPUTER 2(DIGITAL) → COMPUTER2
(ANALOG) → VIDEO → S-VIDEO → COMPUTER1 and displays the first found source.
COMPUTER1
......................Displays the computer signal from the COMPUTER 1 IN connector every time the projector is turned
on.
COMPUTER2(DIGITAL)
.......Displays the DVI digital from the COMPUTER 2 IN connector every time the projector is turned on.
(Not available on NP405/NP305)
COMPUTER2(ANALOG)
......Displays the computer signal from the COMPUTER 2 IN connector every time the projector is turned
on. (“COMPUTER2” on NP405/NP305)
VIDEO
.................................Displays the Video source from the VIDEO IN connector every time the projector is turned on.
S-VIDEO
.............................Displays the Video source from the S-VIDEO IN connector every time the projector is turned on.