147
• TO UNLOCK THE TELEPHONE
STEP 1: Display the Password Entry screen by either
of the following operations.
• Press any key while the screen saver is
activated.
• Press Security while the screen saver is
activated.
STEP 2: Enter the password and press
(Enter) or
OK. Security Lamp goes off and Security
Mode is canceled.
Note
The default password to release a security lock is 0000.
Be sure to change the default password before placing
the telephone in security mode. For details on the pass-
word setting, see TO CHANGE PASSWORD in Termi-
nal Setup.
TIP
When the password entry ends in failure, the following
error message is issued. In that case, press or OK
and retry.
Please input a password.
Security lock will be released.
BK
Cancel
OK
TIP
After a third attempt (if incorrect password is entered
three times consecutively), the following error message
is issued. Press or OK. The telephone locks up,
and any key operation will be disabled for 10 minutes.
Wait for 10 minutes, make a retry. Please note emer-
gency calls cannot be completed during the 10 minutes
terminal lock out period.
Retry?
Password Error.
Cancel
OK
password entered.
Incorrect security code
OK
To Next Page
Loading...
