170
STEP 18:The display goes back to the Edit screen.
Check the memory number assigned to the
directory data being edited.
STEP 19:If you need to assign a memory number man-
ually, select Memory ID on the screen of
the previous step, and enter a desired mem-
ory number (0 - 499).
Enter a memory number by using digits keys. After
entering the memory number, press or OK.
STEP 20:When the display goes back to the Edit
screen, press Save to save the assigned da-
ta.
STEP 21:“The data is registered at memory number:
XX” is displayed. Press or OK. The dis-
play returns to the Directory screen.
Note
You can set illumination type for calls routed from the
specific name (calling party) here. Illumination type can
be set for "Name", "Group" and "Telephone set". The
illumination type set for "Name" has higher priority than
the types set for "Group" and "Terminal set".
Note
Set Default when you don’t want to change the illumi-
nation type here. The setting for “Group” or “Telephone
set” is applied. Also, when Automatic is set, Red is
automatically applied.
TIP
A memory number is automatically set in ascending
numeric order.
9
0
OK
Back
2/2
[Edit]
Save
0
No
Automatic
TIP
If Name is not entered, “No Input Name” will appear.
Name information is required for a entry.
TIP
If a duplicate Memory ID is entered, “It will overwrite a
data at memory number:XX” will appear. If you do not
overwrite the Memory ID, press Back. If you overwrite
the Memory ID, press or OK.
OK
Back
[Memory ID]
Input a Memory number.
BK
1
0-499
0
To Next Page
Loading...
