222
• To switch between “Wired Telephone”
mode and “Mobile Phone” mode
STEP 1: Press the Path key when the terminal is in
idle/ringing status.
STEP 2: The terminal mode is switched. When you lift
the handset or the speaker is ON, the termi-
nal mode cannot be switched.
• To switch mobile phone answer mode
Depending on the specifications of a mobile phone,
the operation to start a conversation after answer-
ing the incoming call with the mobile phone is dif-
ferent. You can start a call smoothly by setting the
mobile phone answer mode according the specifi-
cations of each mobile phone. Choose the mobile
phone answer mode corresponding to the mobile
phone in use.
Smart Device Type (Type 1):
When you answer an incoming call with the mobile
phone, the answered call will be switched from
DT830G to the mobile phone automatically.
Smart Device Type (Type 2):
It is used for the type of mobile phones that delays
the start of a conversation when it answers the call
on Type 1.
STEP 1: Press and hold the Path key when the termi-
nal is in idle status.
STEP 2: You will hear a beep tone when the terminal
mode is switched.
• Smart Device Type (Type 1): The beep tone
sounds once.
• Smart Device Type (Type 2): The beep tone
sounds twice.
Note
Depending on the type of mobile phone, a delay on the
starting of the conversation may happen.
Note
When you use this mode for a mobile phone that can
start immediately a conversation with Type 1, the call
may be on the DT830G.
Note
For details of recommended type of mode, contact the
system administrator.
To Next Page
Loading...
