NEC V230 - Adjusting with the Remote Control

26
3. Projecting an Image (Basic Operation)
Adjusting with the remote control
1. Press the KEYSTONE button.
The Keystone bar will be displayed.
2. Use the  or  button to correct the keystone distortion.
Adjust so that the right and left sides are parallel.
3. Press the ENTER button.
NOTE:
• TheKeystonecorrectioncancauseanimagetobeslightlyblurredbecausethecorrectionismadeelectronically.
• Themaximumrangeofverticalkeystonecorrectionis+/−40degrees.Thismaximumrangemaybesmallerdependingonthe
signaloraspectratiosetting.TheKeystonecorrectionrangewillalsobesmallerwhen3Dmodeisenabled.
• Therangeofkeystonecorrectionisnotthemaximumtiltangleofprojector.
• Theleftandright(horizontal)keystonecorrectionisnotavailable.
TIP:Thechangescanbesavedwith[KEYSTONESAVE].(→ page 63)