NEC V230 - Optimizing Computer Signal Automatically; Adjusting the Image Using Auto Adjust; Turning up or down Volume

27
3. Projecting an Image (Basic Operation)
 Optimizing Computer Signal Automatically
Adjusting the Image Using Auto Adjust
Optimizingacomputerimageautomatically.
PresstheAUTOADJ.buttontooptimizeacomputerimageautomatically.
This adjustment may be necessary when you connect your computer for the first time.
[Poor picture]
[Normal picture]
NOTE:
Somesignalsmaytaketimetodisplayormaynotbedisplayedcorrectly.
• TheAutoAdjustfunctionwillworkforcomputer(RGB)signalonly.
• IftheAutoAdjustoperationcannotoptimizethecomputersignal,trytoadjust[HORIZONTAL],[VERTICAL],[CLOCK],and[PHASE]
manually.(→ page 59, 60)
 Turning Up or Down Volume
Sound level from the speaker can be adjusted.
TIP: When no menus appear, the  and  buttons on the projector cabinet work as a volume control.
NOTE:The[BEEP]soundvolumecannotbeadjusted.Toturnoffthe[BEEP]sound,fromthemenu,select[SETUP]→[OPTIONS
(1)]→[BEEP]→[OFF].(→ page 70)
Increase volume
Decrease volume