NEC V230 - Turning off the Projector

28
3. Projecting an Image (Basic Operation)
7 Turning off the Projector
Toturnofftheprojector:
1. First, press the (POWER) button on the projector
cabinet or the POWER OFF button on the remote con-
trol.
The [POWER OFF / ARE YOU SURE? /CARBON SAV-
INGS- SESSION X.XXX[g-CO2]] message will appear.
2. Secondly, press the ENTER button or press the
(POWER) or the POWER OFF button again.
The lamp will turn off and the projector will go into standby
mode. When in standby mode, the POWER indicator will
light orange and the STATUS indicator will light green when
[NORMAL] is selected for [STANDBY MODE].
Immediately after turning on the projector and displaying an
image, you cannot turn off the projector for 60 seconds.
3. Finally, unplug the power cord.
The POWER indicator will go out.
CAUTION:
Parts of the projector may become temporarily heated if the AC power supply is disconnected either during normal
projector operation or during cooling fan operation. Use caution when picking up the projector.
Power On Standby
Steady green light Steady orange light
NOTE:
• Donotturnoffthepowerfor60secondsimmediatelyafterturningitonanddisplayinganimage.
• DonotdisconnecttheACpowersupplytotheprojectorwithin10secondsofmakingadjustmentorsettingchangesandclosing
themenu.Doingsocancauselossofadjustmentsandsettings.