NEC V230 - Changing Eco Mode

31
4. Convenient Features
 Changing Eco Mode
This feature enables you to select two brightness modes of the lamp:
OFF and ON modes. The lamp life can be extended by turning on the [ECO MODE].
[ECO MODE] Description Status of LAMP indicator
[OFF] This is the default setting (100% Brightness). Off
STATUS
LAMP
[ON] Select this mode to increase the lamp life (approx.
90% Brightness on V260X/V230X/V260/V230 and
approx.75% Brightness on V300X.)
Steady Green light
STATUS
LAMP
To turn on the [ECO MODE], do the following:
1. Press the ECO button on the remote control to display [ECO
MODE] screen.
2. Use the  or  button to select [ON].
3. Press the ENTER button.
To change from [ON] to [OFF], Go back to Step 2 and select [OFF].
Repeat Step 3.
NOTE:
• The[ECOMODE]canbechangedbyusingthemenu.
 Select[SETUP]→[GENERAL]→[ECOMODE].
• Thelampliferemainingandlamphoursusedcanbecheckedin[USAGETIME].
Select[INFO.]→[USAGETIME].
• The projector willalwaysenter into the[ECOMODE] [ON] condition for90
secondsimmediatelyaftertheprojectoristurnedon.Thelampconditionwill
notbeaffectedevenwhen[ECOMODE]ischangedwithinthistimeperiod.
• Afteralapseof45secondsfromwhentheprojectordisplaysablue,blackor
logoscreen,[ECOMODE]willautomaticallyswitchto[ON].Thisisdoneonly
when[ECOMODE]issetto[OFF].
• Iftheprojectorisoverheatedin[OFF]mode,theremaybeacasewherethe[ECO
MODE]automaticallychangesto[ON]modetoprotecttheprojector.Whenthe
projectorisin[ON]mode,thepicturebrightnessdecreases.Whentheprojector
comesbacktonormaltemperature,the[ECOMODE]returnsto[OFF]mode.
 Thermometersymbol[ ]indicatesthe[ECOMODE]isautomaticallysetto
[ON]modebecausetheinternaltemperatureistoohigh.