NEC V230 - Page 83

74
5. Using On-Screen Menu
[3D]
[V230X/V260/V230] [V300X/V260X]
Selecting input connected to a source of 3D images [COMPUTER / VIDEO / S-VIDEO] (V230X/V260/V230)/
[COMPUTER 1/COMPUTER 2/VIDEO/S-VIDEO] (V300X/V260X)
[3D]
This function switches the 3D mode between ON and OFF for each input.
ON ������������������������� Turns on the 3D mode for the selected input�
NOTE:
To confirm that the supported 3D signal is accepted, use either way of the following:
- Make sure that [3D] is displayed in the top right of the screen after the source is selected.
- Display [INFO.] → [SOURCE] → [3D SIGNAL] and make sure that "SUPPORTED" is displayed.
OFF
������������������������ Turns off the 3D mode for the selected input�
[GLASSES]
Select a 3D glass method.
DLP
®
Link ���������������������������For the optional 3D supported goggles (NP01GL) or DLP
®
Link compatible LCD shutter eyeglasses�
Nvidia 3D Vision*1 �������������For NVIDIA
®
3D Vision
TM
NOTE:
This function will not work for VIDEO or S-VIDEO source.
In some cases when NVIDIA
®
3D Vision™ is used, the projector’s remote control may not work well.
If you use LCD shutter eyeglasses that are not compatible with DLP
®
Link, the LCD shutter eyeglasses
may not synchronize to the projector properly.
Others*2
�����������������������������For other LCD shutter eyeglasses such as IR or wired LCD shutter types�
*1: For V300X only
*2: For other models than V300X
[FORMAT]
Selects either two formats: frame sequential or over/undert
FRAME SEQUENTIAL
����������Normal setting� (frame sequential 3D consists of a sequence of alternating frames wherein each
successive frame carries the image meant for one or the other eye�)
OVER/UNDER ���������������������For viewing a 3D images in under/over format�