NEC V230 - Page 91

82
6. Maintenance
5. Connect the supplied power cord, and turn on the projector.
6. Finally, select the menu → [RESET] → [CLEAR LAMP HOURS] to reset the lamp usage hours.
NOTE:Whenyoucontinuetousetheprojectorforanother100hoursafterthelamphasreachedtheendofitslife,theprojector
cannot turn on and the menu is not displayed.
Ifthishappens,presstheHELPbuttonontheremotecontrolfor10secondstoresetthelampclockbacktozero.
Whenthelamptimeclockisresettozero,theLAMPindicatorgoesout.
4. Reattach the lamp cover.
(1) Slide the lamp cover back until it snaps into place.
(2)Tightenthescrewtosecurethelampcover.
 •Besuretotightenthescrew.
3. Install a new lamp housing.
(1) Insert a new lamp housing until the lamp housing is plugged into the socket.
CAUTION
DonotusealampotherthantheNECreplacementlampNP18LP(V300X)/NP13LP(V260X/V230X/V260/V230).
Order this from your NEC dealer.
(2)Pushthetopcenterofthelamphousingtosecureit.
(3)Secureitinplacewiththethreescrews.
 •Besuretotightenthescrews.
Hold the cabinet with your hand to keep it from tilting while you tighten the screw.