Setting Up and Using the Software 3-21
n /Rx — Reboot system after configuration
x 0 = System port reboot
1 = Far jmp F000:FFF0h (hard reset address)
For example, the following command line disables the SCSI
port:
device=c:\ds4000\scsictrl.sys /S0
The following example disables the SCSI port and then re-
boots the system using the system port:
device=c:\ds4000\scsictrl.sys /S0 /R0
The next example enables the SCSI port and specifies an
alternate IRQ:
device=c:\ds4000\scsictrl.sys /S1 /Q4
Do not use a drive connected to this port as
the boot drive for your operating system. Due to the
system configuration routine, booting from this port
usually fails.
To Next Page
Loading...